Jet Power-Flow Mass Air Sensor

A GOOD INVESTMENT

Posted on 12/20/2008 by Jim P. - 2004 Cadillac Escalade (Phoenix,AZ)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"A little more pick up on the acceleration and a mile or two on the MPG well woth the money and time"

Was this review helpful? Yes No

Must give it more time

Posted on 12/20/2008 by Kevin G. - 2007 Nissan Altima (Nicholasville,KY)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"I have noticed a quicker response off the line. I need to get it on the road to see if there are any MPG gains."

Was this review helpful? Yes No

Jet Maf

Posted on 12/20/2008 by Louis S. (Cinnaminson,NJ)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Was not going to purchase at first. But after install to my surprise I seen a 3 tenth gain 0to60 on my Gtech meter immediatly after install.Do not know about the mileage improvement yet.I am getting one for my other Nissan vehicle as soon as they are back in stock."

Was this review helpful? Yes No

2007 GMC Sierra Jet Power Mass Air Flow Sensor

Posted on 12/05/2008 by Bryce A. - 2007 GMC Sierra (Rancho Palos Verdes,CA)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"The Jet Power-Flow sensor was easy to install, it was the same form factor as the stock unit. No issues with any engine lights or warnings. I noticed an increase in low end pulling power right way. I can not tell if MPG will be effected yet."

Was this review helpful? Yes No

Jet maf sensor

Posted on 11/27/2008 by William P. - 2008 Ford F-250 (Centreville, Va,VA)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Its easy to install, (less than 5 minutes), improves both power and mileage, (immediately evident), I highly recommend it, thanks."

Was this review helpful? Yes No

Jet Power

Posted on 11/26/2008 by Nick A. - 2002 Ford F-150 (Cedar Rapids,IA)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Great quality and appearance. Good addition to my volante cold air intake"

Was this review helpful? Yes No

Postive results - HHR 2006 2LT 2.4L Auto

Posted on 11/25/2008 by Henry G. - 2006 Chevy HHR (Cortlandt Manor,NY)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Improved engine aspiration, breaths better, you can feel the quicker acceleration and torque. I have it working with a K&N cold air intake system. The cold air intake was installed prior, so I felt the difference. My mileage did improve by 2-3 mi/gal, I commute from North of NYC to Wash,D.C.(560 miles/rd trip)every week. I would highly recommend to others, sound long term investment.....you get mileage and acceleration."

Was this review helpful? Yes No

Jet Power-flow installed without problem on CTS

Posted on 11/18/2008 by Stephen L. - 2005 Cadillac CTS (Raleigh,NC)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"The Jet Power-flow does produce low end torque. Gas milage has increased according to computer, and will probably be better as soon as I quit kicking it to test the low end power. I have only put about 60 in town miles on it so far but expect it will improve. A concern for me was, installation on my CTS under warranty. It went in with setting off any service lights. Everything works perfectly. At $300 it is not cheap, but it is an easy upgrade. Eventually, I will recover the cost of fuel."

Was this review helpful? Yes No

JET MASS AIR SENSOR

Posted on 11/03/2008 by Jameel H. - 2003 GMC Yukon XL (Copiague,NY)

1 of 1 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"VERY EASY INSTALL.TOO EARLY TO TELL OF ANY MPG IMPROVEMENTS.NOTICEABLE IMPROVEMENT IN OVERALL ENGINE POWER.AUTO ANYTHING HAD THE LOWEST PRICE I COULD FIND PLUS AVAILABLE COUPONS AND FREE SHIPPING!!"

Was this review helpful? Yes No

Seems to work good - Super easy install.

Posted on 10/20/2008 by Daniel K. - 2007 Ford F150 (Iowa City,IA)

2 of 2 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Installed this in my 2007 F-150 in about 5 minutes. Can feel a slight improvement in throttle response but have not checked the mileage yet."

Was this review helpful? Yes No

2008 HHR 2LT

Posted on 10/17/2008 by Lynn G. - 2008 Chevy HHR (Freeville,NY)

2 of 4 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"runs 1000% better (Real Fast)"

Was this review helpful? Yes No

2004 Ford Ranger 3.0

Posted on 10/16/2008 by Jaime B. - 2004 Ford Ranger (Alta Loma,CA)

1 of 2 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Very happy well worth the money. I noticed a differance rite away with a faster throtle response and more power to get my 35 inch tires up hills. Thanks"

Was this review helpful? Yes No

Bang For Your Buck

Posted on 10/09/2008 by Daniel T M. - 2004 Hummer H2 (Diamond,MO)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"I just put on the Jet Power-Flow Mass Air sensor on our 04 Hummer H2 along with a cold air intake by AFE. With the two together there is a huge differance in our performance and fuel milage. Our Hummer got 15-16 MPG before and so far since the installation we have noticed a 2mpg increase and a HUGE differance in Horsepower and Torque. Well worth the money spent. Thank You Daniel"

Was this review helpful? Yes No

Mass Air Flow Sensor

Posted on 10/06/2008 by Brian M. - 2003 Cadillac Escalade (Navarre,FL)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"This had to be one of the easiest bolt-ons ever! In 10 minutes or less, it was installed. The additional power was noticed right away. Increased fuel economy has been 1 - 2 MPG, but I have been enjoying the extra ponies so much that it's really hard to judge!"

Was this review helpful? Yes No

Sensor replacment

Posted on 10/04/2008 by Richard B. - 2000 Ford Expedition (Hoquiam,WA)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"I replaced the stock sensor that was connected to a K&N intake system. I'm still collating the data to see if it has made a significant difference. I feel a little more horse power but not sure on gas mpg gains."

Was this review helpful? Yes No

So far it's good!

Posted on 09/26/2008 by Royce C. - 1999 Ford F-150 (York,PA)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"I installed the larger JET MAF sensor on a '99 F150 4.6 v8 (w/ 109,000 miles) to see if it helped with the stumble I was having when you would goose it in 3rd & 4th gear. So far it seems to be helping and is probably what I needed in the first place since I have an intake and Borla exhaust system on the truck. The JET works really well with the intake! I have not really noticed any power increase, but the computer may still be learning the new curve. I am pretty sure my gas mileage went way up though, because I just got back from a 106 mile hilly trip and used only about a quarter tank of fuel!! (I normally only get 300 per tank if I'm lucky). So, we'll see- but I'm happy with it so far!"

Was this review helpful? Yes No

Jet Power Mass Air Sensor

Posted on 09/25/2008 by Michael B. - 2004 Cadillac Escalade (South Pittsburg,TN)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"This mass air flow sensor was very easy to install. Took maybe 10 to 15 minutes. With the price of gas heading up these days I figurd I give this Jet Power product a try. So far I might have picked up a mile or two. The Jet Power Mass air flow sensor I'm hoping will pay for itself in the long run. This company(Jet Power) is well know for its computer chips and mass air flow sensors!"

Was this review helpful? Yes No

Power and Mileage 2004 5.3L Z71

Posted on 09/23/2008 by Tim W. - 2004 Chevy Silverado (Elkin,NC)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"The Jet Power-Flow Mass Air Sensor is well built easy to install and does what it says it does. I would say I got at least 15 to 18 more horse power and 1 to 1.5 MPG. I love it. I also have a K&N cold air intake , UNICHIP , and Gibson cat-back."

Was this review helpful? Yes No

2006 Toyota Tacoma Mass Air Sensor

Posted on 09/21/2008 by John S. - 2006 Toyota Tacoma (Marianna,PA)

0 of 0 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Made a differance on the hills. Easy installation."

Was this review helpful? Yes No

Great Up-Grade

Posted on 09/12/2008 by Peter U. - 2005 Toyota 4-Runner (California City,CA)

3 of 3 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Install in minutes. 2 to 3 Mile a gal increase. Helped map shifting for pulling trailer. Great Product"

Was this review helpful? Yes No

07 Tundra 4.7l

Posted on 09/11/2008 by Loc H. - 2007 Toyota Tundra (Orange,CA)

2 of 2 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"The installation was a piece of cake, I notice the power gained right away as far as the mpg I don't see any changes."

Was this review helpful? Yes No

good power & mpg for the money

Posted on 08/14/2008 by Kevin H. - 2007 Chevy Monte Carlo (Arlington,TX)

3 of 4 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"This couldn't have been easier to install on my wife's 07 Monte Carlo SS. Taking my time it may have taken about 30 minutes. I also have the K & N FIPK cool air intake installed. This MAS looks just like the stock unit on the sexterior and does exactly what it says-it saves gas on cruising mode and opens up performance when wide open throttle. On level ground at a pace of 40-45 mph it is giving us 35-40 mpg according to the ECU readout in the dash. This is up from the 30-35 prior to install. This is with the 303 hp 5.3 LS-3 engine with displacement on demand (V8 to V4). This MC SS now does 0-60 in about 5 sec! And has been giving us 22.6 mpg in city driving here in DFW, TX."

Was this review helpful? Yes No

Air flow

Posted on 08/10/2008 by Matthew R. - 2005 Pontiac G6 (San Antonio ,TX)

2 of 3 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"The ease of removing my old air sensor and installing my new mass flow air sensor was very easy, no problem with any of the steps. The results have been seen more in the city and same result on the high way. I am still seeing an average of 30-31 mpg on the highway but an increase in the city from 24 to about 26. I only been able to run two tanks of gas so we will have to see if something else in MPG changes. I have seen a slight increase in horse power from the stop position and an increase in rate of excelleration on the high way. I step on the peddle and before i know it im doing 100MPH!! I'm not sure if it was worth $300 dollars but it will eventually pay itself off, so what can i loose."

Was this review helpful? Yes No

Jet MAF

Posted on 07/31/2008 by Oliver P N. - 2006 Pontiac Grand Prix (Philadelphia,PA)

3 of 5 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"Good overall performance. Gave me more top end power. Very quick and east to install. Definitely needs a 'HPTuner' to dial it in correctly to get the most performance. That'll be real soon for me. I don't see any MPG gains from it. More air you have the more fuel you'll need to 'mix and burn'. If performance is what you want then it's well worth the money. Don't get this if you want to be economical with your car. I was surprise that it didn't come with a wire mesh screen. I had to utilize the old factory one. More performance without the screen, but poor gas mileage."

Was this review helpful? Yes No

Good-to-Go!

Posted on 07/16/2008 by Brian W. - 2006 Chevy Cobalt (Guyton,GA)

3 of 4 people found the following review helpful.

Appearance

Ease of Installation

Price/Value

Quality

"I installed the sensor in a matter of minutes on my 06' Cobalt. I did notice an increase in passing power and an increase of 2 MPG! I am very satisfied so far and look forward to installing some other go-fast bits!"

Was this review helpful? Yes No